GE PVW7301 Instrucciones De Instalación página 7

Installation Instructions
PREPARE HOOD FOR INSTALLATION
Remove the greose filter from the unit and set
oside. The greose filter is removed by pressing
the handle in front of the filter. When replacing,
make sure that the filter is
properly positioned with the
handles in front and visible.
Vented Installations
1. Securely press the damper
on top of the exhaust opening. Check that the
damper opens freely.
2. Remove and properly discord the protective
plastic wrapping from the hood and grease
filter.
3. Go to Mount the Glass Range Hood section.
Non-vented {ductless)Installations
NOTE: A recirculetion duct, extensions, and
bracket ere all included with the hood end
ere necessary for recirculetion installation. A
charcoal filter, not included, is also needed
for recirculation installation. The damper is
not installed on the unit with recirculation
installation.
1. Install the recirculetion duct extensions to the
recirculetion duct.
2, Attach the recirculution duct mounting bracket
to the recirculution duct using the duct cover
screw supplied with the hardware package,
Attach Using
Duct Cover
Screw
.
Fit the recirculotion duct with extensions over
the vent exhaust outlet and push down to seat
on outlet. Attach the vertical duct work to the
top of the hood. Check that the recirculution
duct is in the proper orientation (hole facing
towards the buck of the hood).
J
Recirculation
Duct with -Vent Exhaust
Extensions Outlet
NOTE:
Hole must
be facing
toward back
of hood.
4. Go to Mount the Glass Range Hood section.
MOUNT THE GLASS RANGE HOOD
.
NOTE: If ductless (recirculation)installation,
follow steps 1-6. If ducted installation, follow
steps 1-3.
Using 2 or more people, lift the range hood and
place on the hood mounting bracket. Make
sure the bracket fully engages the holes on the
hood body.
Duct Cover
;_'_ Screw
I
.
Place a mounting screw into the duct cover
anchor at the center slot provided on the
bottom of the back side of the hood. Securely
tighten.
.
Mounting Screw
Secure the hood to the mounting bracket by
fastening a duct cover screw in hole (B) on both
sides of bracket shown previously
!
Z
¢/9
I--
I--
!
O
Z
!
Z
¢/9
--I
C
--t
!
O
Z
31 11007
7