Qilive Q.1108 Manual De Instrucciones página 8

Inserting batteries into remote control
EN
1. Remove the battery compartment cover.
2. Insert two AAA/1.5V batteries into the battery compartment.
Make sure that you follow the correct polarity (+, -) as indicated in the battery
compartment when installing batteries.
3. Replace the cover.
6. USE
6.1. TURNING THE UNIT ON/OFF
1. Using the supplied AC power cord, connect the AC IN socket to a suitable power
supply.
2. To turn the unit on, press the
3. To switch to standby, press
6.2. USING THE REMOTE CONTROL
Point the remote control at the remote sensor on the front panel. The remote control
works within a distance of about 8 meters from the sensor and within an angle of about
30 degrees from left and right.
6.3. ADJUSTING VOLUME
Press the +/- buttons on the remote control (or soundbar) to adjust the volume.
6.4. SWITCHING MODE
repeatedly to switch among Bluetooth, LINE IN, USB, OPTICAL IN and ARC
Press
mode. You should choose the mode based on the device currently connected.
6.5. LINE IN
You can input the analogue stereo audio signals from
extra devices such as VCD, CD, VCR, DVD player, etc.
1. Use the 3.5mm audio cable (supplied) to connect
the stereo audio output terminals of a VCD, CD,
VCR, or DVD player to the stereo input terminal
LINE IN of this soundbar.
2. repeatedly to switch to LINE IN mode. The
Press
indicator light will keep solid green when devices are
correctly connected.
6.6. OPTICAL INPUT
1. Use the optical cable (not supplied) to connect the
optical input of this sound bar to the optical output of
VCD, CD, VCR, or DVD player.
2. repeatedly to switch to OPTICAL IN mode.
Press
The indicator light will keep solid yellow when
devices are correctly connected.
button on the top panel or remote control.
.
8
Line input Optical input
LINE IN
OPTICAL
Optical output
Line output