Klarstein SANTA ELENA Manual Del Usuario página 22

EN
22
Assembling and Hanging the Fan
electical wiring
hanging ball
slot
R clip
adapter
If you wish to extend the hanging length of your fan, you must remove the
hanging ball from the 6 inch downrod provided to use with an extended downrod
(included) . (If you wish to use the 6 inch downrod, please proceed to instructions
below.)
To remove hanging ball, loose set screw on hanging ball and remove pin and
clip. Lower hanging ball and remove stop pin. Slide hanging ball off the original
downrod A, and slide it down the longer downrod B (the top of the downrod
should be noted as having a set screw hole; use this hole when setting the set
screw).
Insert stop pin into top of extended downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of the hanging ball, tighten set
screw securely.
Tip: To prepare for threading electrical wires through downrod, apply small piece
of electrical tape to the ends of electrical wires-this will keep the wires together
when threading them through the downrod.
Loosen yoke set screws and nut at top of motor housing. Remove pin
and clip from downrod (if you have not already done so). Slide downrod
through canopy.
Tread electrical wires through downrod and pull extra wire slack from
the upper end of the downrod.
Place downrod into the motor housing yoke. Insert the stop pin and clip that were
previously removed. Tighten yoke set screws and nut securely. Lower the canopy
to motor housing.
canopy
decorative covers
stop pin
yoke set screw