Panasonic ES-EL2A Instrucciones De Funcionamiento página 10

Charging
For best performance, fully charge the
appliance before use.
You cannot operate the appliance while
charging.
Charging time = Approx. 1 hour
The epilator can be used for
approximately 30 minutes
(35 minutes when using the gentle cap)
after 1 hour of charging. (This will differ
depending on the temperature.)
Plug the AC adaptor into the
epilator ( ) and a household
outlet ( ). (Fig. 1)
• Red light appears while charging. (Fig. 2)
• Red light goes off after charging is
completed. (Fig. 3)
• Red light blinks twice every second
when abnormal charging. (Fig. 4)
• Recommended ambient temperature for
charging is 15 °C – 35 °C. The battery
may not charge properly or not at all if
outside the recommended temperature.
• The charging time may decrease
depending on the charging capacity.
• Charging the appliance every time it is
used will not affect the life of the
rechargeable battery.
• When charging the appliance for the
first time or when it has not been in use
for more than 6 months, the charging
time may change or the charging
indication/notification light may not
glow for a few minutes. It will eventually
glow if kept connected.
• If there is noise from the radio or other
sources while using or charging the
appliance, move to a different location
to use the appliance.
<To check if charging is completed>
If you remove and reinsert the appliance
plug while charging, the charging
indication/notification light glows and
turns off after approximately 5 seconds.
16
PB015615 - EL8A-3A-2A _(01GB)_11-07-17.indd 16
Before use
Selecting the head
Remove the head while pushing
the head release button and push
the head until it clicks. (Fig. 5)
Using the bikini comb
ES-DEL8A/ES-EL8A
Place the bikini comb onto the
shaver head and slide trimmer
up. (Fig. 6)
• When the bikini comb is in place, make
sure the comb is in close contact with
the skin.
<LED light> (Fig. 7)
The LED light comes on when the
power is turned on. The light will remain
on while the power is ON.
<Mode selecting function> (Fig. 8)
• The disc rotation speed can be
switched between 3 stages. Try using
the SOFT mode when you are
concerned about irritation when
removing hairs.
• Operation will change in order from
●(SOFT) ●●(NORMAL)
●●●(POWER) "OFF" each time the
power switch is pressed.
• When using the foot care head, using
the POWER mode is recommended.
●: SOFT
The disc will rotate at a low speed.
• 1 of Mode lamps will glow blue.
●●: NORMAL
The disc will rotate at a normal speed.
• 2 of Mode lamps will glow blue.
●●●: POWER
The disc will rotate at a high speed.
• 3 of Mode lamps will glow blue.
OFF
The power will be switched OFF.
2017/11/7 11:11:21