Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE WALL CONTROL
WARNING: All wiring must be in accordance with the National Electrical Code
and local electrical codes. Electrical installation should be performed by a
qualified licensed electrician.
NOTE: SWITCH INSTALLATION MUST COMPLY WITH ALL LOCAL AND
NATIONAL ELECTRIC CODE.
WARNING: Shut off main power at the circuit breaker or fuse panel before
continuing.
Step 1. Remove the existing wall plate and the old switch from the wall outlet box.
Disconnect wires. (Fig. 15)
Step 2. Place the wall control to the outlet box, connect the wires with wire
connectors provided. (Fig. 16)
*Connect the lead wire (HOT) from the outlet box to BLACK wire marked
"AC IN L" from wall control.
*Connect the lead wire (LOAD) from the outlet box to BLACK wire marked
"TO MOTOR L" from wall control.
*Connect the GROUND from the outlet box to GROUND from wall control.
Step 3. Secure the wires connectors and make sure there are no loose strands or
connections. Carefully tuck wire connections back inside outlet box and secure the
wall control to outlet box with screws provided. Snug the face plate to wall control.
14 | KICHLER.COM
Outlet Box
Switch
Fig. 15
Wall Control
Outlet Box
HOT
TO 120V SOURCE
TO LOAD
GROUND WIRE
FROM CEILING
Fig. 16
Wall Plate
Face Plate
Publicidad
