ELECTRICAL CONNECTIONS
WARNING: To avoid possible electrical shock, be sure you have turned off the power at the main circuit panel before wiring.
Follow the steps below to connect the fan to your household wiring. Use the wire connectors supplied with your fan. Secure the
connector with electrical tape. Make sure there are no loose wire stands or connections.
WARNING: If your house wires are different colors than referenced in this manual, stop immediately.
A professional electrician is recommended to determine proper wiring.
Step 1. Place the receiver into the mounting plate cover and keep flat in opposition of ceiling. (Fig. 8)
Step 2. Motor to Receiver Electrical Connections:
Connect the WHITE wire from the fan to WHITE wire marked "TO MOTOR N" from the receiver. Connect
the BLACK wire from the fan to BLACK wire marked "TO MOTOR L" from the receiver. Connect the
BLUE wire from the fan to BLUE wire marked "FOR LIGHT" from the receiver.
Step 3. Receiver to Household Electrical Connections:
Connect the WHITE wire marked "AC IN N" from the receiver to the WHITE wire from the house. Connect
the BLACK wire marked "AC IN L" from the receiver to the BLACK wire marked "TO MOTOR L" from the
wall control.
Connect the BLACK wire marked "AC IN L" from the wall control to the BLACK wire from the house.
Step 4. Ground wires connections:
Connect the GROUND wire from the house to the GREEN wires from the motor assembly and mounting plate.
Step 5. Secure all wires connections with the plastic wire connectors provided. (Fig. 9 )
NOTE: After connecting the wires, spread them apart so that the green and white wires are on one side of the outlet box and black and
blue wire and on the other side. Carefully tuck the wire connections up into the outlet box.
NOTE: Fan must be installed at a maximum distance of 30 feet from the transmitting unit for proper signal transmission between the
transmitting unit and the fan's receiving unit.
Receiver
Mounting
Plate Cover
Fig. 8
48"/ 54" Volos LED | 9