Signal Check; Power Save Mode - Hitachi PW1A Manual De Usuario

OTHER FEATURES (continued)

Signal Check

Changes in the signal status are displayed on the screen as they arise.
Status
When Mode Display is set to ON,
the input signal is switched or
when the RECALL button is
pressed.
When the sync signal is no longer
detected.
When the input signal does not
match the monitor specifications
or is in an unstable status.

Power Save Mode

When the RGB1, RGB2 input is selected
• When this unit is connected to a VESA DPMS computer, the Power Save (Off) mode can be set to be activated automatically when the
computer is not being used to reduce power consumption by this unit.
RGB sync signal
PC signal
Operation mode
Indicating lamp
Power consumption
Returning to operating status
• Operate the personal computer, or press either the INPUT SELECT button of the main unit or the RGB1/RGB2 buttons of the remote control.
Display
A guide is displayed for the input
terminal and the horizontal and
vertical sync frequency.
• A guide displays No Sync. Recheck the personal computer
Signal, and Power Save (for power switch status and the
approx. 5 sec.) connection status.
• When the condition continues
where the sync signal cannot be
detected, indicator lamp of
power source changes in
orange and the mode switches
to power save mode.
A guide displays Invalid Scan Recheck the input signal
Freq. specifications.
Horizontal
Vertical
Active (normal display)
Lights green
Action
Yes No
Yes Yes
On
3W or less (RGB1)
1W or less (RGB2 ; 100V AC 120V)
310W
3W or less (RGB2 ; 120V AC 240V)
RGB
-- -- Min.
OFF
-- -- : -- --
! No Sync. Signal
! Invalid Scan Freq.
Yes No
No No
Blank (no display)
Off
Lights orange
RGB2
RGB
H : 48.4kHz
V : 60.1 Hz