Hitachi PW1A Manual De Usuario página 44

OPERATING INSTRUCTIONS (continued)
SETUP MENU (continued)
Selected characters
Audio Input
AV1
AV2
AV3
AV4
Scart Output
RGB1
RGB2 (1st step)
RGB2 (2nd step)
OTHER FEATURES
Automatic Store
Approximately 1 sec. after adjustment is completed, the adjustments will be recorded as shown in the table below.
Menu Display
Picture
Picture Mode
Contrast
Brightness
Color
Sharpness
Tint
Color Temperature
Contrast Mode
YNR
CNR
Film Mode
PAL Comb Filter
LTI
CTI
Black Enhancement
Auto Color
Color Temp. Adjust
R Amplitude For every Color Temperature, 1
G Amplitude
B Amplitude
R Cut Off
G Cut Off
B Cut Off
Color Management
Magenta 1 setting is registered.
Stereo L/Mono
DVI-PC DVI-STB
RGB Component
Auto HDTV SDTV/DVD
Registration condition
1 setting is registered.
For every input function and every
Picture Mode, 1 setting is
registered.
setting is registered.
For every input function and every
Picture Mode, 1 setting is
registered.
Red
This should correspond to the audio signal from the equipment that is
connected to AV1 audio input terminal. If it is monaural audio, set this to
L/Mono.
(Same to AV1)
Not Available (grayed out)
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB1 DVI terminal.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
This step should be set only when [Component] is selected on the 1st
step.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
Menu Display
Picture Yellow 1 setting is registered.
Green
Color Decoding
Green
Function Video Power Save
Setup
System
Color System
Video Input
Audio Input
RGB1
RGB2
• The previously recorded items will be lost.
Setup hint
Registration condition
Cyan
Blue
-
Red For every Color Temperature, 1
setting is registered.
Color For every input function and every
Picture Mode, 1 setting is
Tint
registered.
1 setting is registered.
1 setting is registered.
1 setting is registered.
AV1
AV2
AV3
AV4
-
AV1 1 setting is registered.
AV2
AV4
-
AV1 1 setting is registered.
AV2
AV3
AV4