Publicidad
Idiomas disponibles
Idiomas disponibles
Step 2 Finish:
(low degree of abrasion-high degree of gloss) Apply
with polishing sponge.
Application: Apply a little polish to the respective pad, rub
in with the machine switched off and start polishing at
low speed. Now increase the speed and polish for a few
seconds at high speed (not maximum). Do not polish too
long on the same spot. Clean surface with microfiber
cloth after all steps. Wash out polishing sponge between
steps. If necessary, repeat polishing step.
7 Accessories for the WP/E angle polisher
Naturally enough, all the items described above (except
metal polishing paste) are also available as accessories
from Proxxon.
For more detailed information on accessories, please
request our device catalogue from the address specified
on the last page in the warranty information.
Please note in general:
Proxxon bits and cutters have been designed to work
with our machines, which makes them optimal for their
use.
We will not assume any liability whatsoever for the safe
and proper function of our devices when using third-
party bits and cutters!
Service note
Please note: The mains power input may only be
replaced by our Proxxon Service Department or a qual-
ified specialist!
8 Care and maintenance:
The device is broadly maintenance-free. For a long ser-
vice life, you should clean your unit after every use with
a soft cloth or brush.
The exterior of the housing can be cleaned with a soft,
possibly damp cloth. A mild soap or other suitable
cleaning agent may be used during this. Solvents or
cleaning agents containing alcohol (e.g. petrol, cleaning
alcohols etc.) should be avoided, since these can attack
plastic casings. In any event, make absolutely certain
that no liquids penetrate into the interior of the device.
- 16 -
9 Disposal:
Please do not dispose of this machine in household
refuse! The device contains reusable materials which
can be recycled. If you have any questions about this,
please contact your local disposal company or other
appropriate local facilities.
EC Declaration of Conformity
Name and address:
PROXXON S.A., 6-10, Härebierg, L-6868 Wecker
Product designation:
Article No.:
On our sole responsibility, we declare that this
product conforms to the following directives and
normative documents:
EU Machinery Directive
EN 60745-1:2009
EN 60745-2-3:2011
EU EMC Directive
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
EU-RoHS-Directive
Date: 16.08.2022
Jörg Wagner (Dipl.-Ing.)
PROXXON S.A.
The person authorised to compile the technical
documents is identical to the signatory
WP/E Angle Polisher
28660
2006/42/EC
2014/30/EC
2011/65/EU
Publicidad
