Publicidad
Idiomas disponibles
Idiomas disponibles
STRIPPING PAINT
The Precision Heat Tool does not overheat the surface or scorch wood easily, unlike radiant heat and
open flame devices such as a propane torch. The heat tool heats up the surface and causes the paint
to soften, at which time it can be scraped off easily without damaging the surface.
Only oil paints were used prior to 1942, and such paints soften easily with heat and can be scraped
off as soon as the finish has blistered. Today's paints are more varied, so generalized results cannot
be predicted. Some paints may soften even though they do not blister; some may become rubbery,
and some may require higher heat. When working with several layers of paint, it speeds up the
scraping process to heat the surface thoroughly, all the way to the wood. Then all the layers can be
scraped at one time. A soft wire brush may be the best tool to use for very intricate surfaces. Mineral
paints and finishes, such as cement paint and porcelain, do not soften with heat, so using a heating
tool will not work for paint removal.
SHRINK TUBING
The shrink tube accessory can be used whenever circular airflow is required. lt is often used to shrink
the tubing around electrical connections, or to soften a plastic tube that must be bent at a specific
location.
IMPORTANT: The shrink tube attachment becomes very hot during use. Allow the attachment to cool
before removal or storage. Slide the shrink tube attachment over the nozzle of the heat tool. Use this
attachment only to shrink tubing. Attach only when the heat tool is cool to touch.
STORAGE
Allow the hot tool nozzle to cool to room temperature before placing in storage. The nozzle will turn
dark over time because of the high heat. This is normal and will not affect the performance or life of
the unit.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
DISPOSAL
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment. Contact your local solid waste authority for
recycling information or give the product for disposal to BGS technic KG or to an electrical
appliances retailer.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
