Publicidad
The rear left digit indicates
number indicating the type of menu. The
front left digit indicates a number which
depends on the parameters indicated in
the selection.
Select the digit with
the power bar.
Select the front left digit and select the
correct setting.
10. HOB FUNCTIONS
Child lock
This function prevents accidental use of the appliance. This cannot be used during a cooking operation
To enable: remove all cookware from the appliance, turn the appliance off. If there is no pan on the hob,
press and hold for 3 seconds one of the 5 digits (not visible) next to the point
and slowly swipe along the power bar from 0 to BOOST. All the digits that indicate
The operations described must be completed within 10 seconds.
To disable: turn the appliance on and then press and hold any of the 5 digits for 3 seconds. Release and
slowly swipe along the power bar from BOOST to 0. The 5 digit displays will lit up indicating and 0 power
level.
The operations described must be completed within 10 seconds.
Lock
It is possible to lock the hob functions during use, e.g. to clean the hob. The function is enabled even if the
hob is switched off and on again.
If the electricity supply is cut, the function is disabled.
To enable: press
To disable: press
Boost function Every cooking area can be set to an additional power level for a maximum of 5 minutes.
To enable: select one of the 4 cooking areas and select "P" on the power bar. The corresponding digit indic-
ates
.
To disable: select one of the other possible values on the power bar.
Cooking zone
The timer allows a specific cooking area to be switched off when the set time expires.
The cooking areas can be programmed individually because each one has its own timer.
timer
To enable: With the cooking area in operation, press to access the timer management controls for that zone.
The 3 digits indicate "0 0 0". Press "+" or "-" to set the timer countdown.
To confirm the set time, do not touch anything for 10 seconds.
When the countdown has finished, the digits are reset and an audible signal is emitted. The function can be
interrupted by pressing any key.
If the timer is enabled for more than one cooking area, the 3 digits will always show whichever timer is about
to finish first.
To deactivate: with the cooking area in operation, press to access the timer management controls for that
zone.
Set the three digits to "0 0 0" using "+" or "-" or press the On/Off key.
and a
and press "8" in
and hold for 1 second.
.
Hours - Tenths - Minutes
See the following table for the specifica-
tions:
Value on the
KW Notes
power bar
0
7.4 Standard initial setting
1
4.5
2
3.5
3
2.8
Once the correct value has been
entered, confirm by touching and hold-
ing
.
on the left side. Release
.
25
Publicidad
