AEG BPK556260B Manual De Instrucciones página 66

11.4 Pyrolytic Cleaning
WARNING!
There is a risk of burns.
CAUTION!
If there are other appliances installed in
the same cabinet, do not use them at the
same time as this function. It can cause
damage to the oven.
Do not start the function if you did not fully
close the oven door.
When the cleaning starts, the appliance door
is locked and the lamp is off. Until the door
unlocks the display shows
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories and removable
shelf supports.
3. Clean the oven floor and the inner door
glass with warm water, a soft cloth and a
mild detergent.
4. Turn the knob for the heating functions to
enter the menu
5. Turn the control knob to select Cleaning
and press
Option
C1 - Light cleaning
C2 - Normal cleaning
C3 - Thorough cleaning
6. Turn the control knob to select the
cleaning programme and press
7. Press to start cleaning.
8. After cleaning, turn the knob for the
heating functions to the off position.
When the oven is cool again, the door
unlocks.
9. Wait until the appliance is cold and then
clean its interior with a soft cloth.
11.5 Cleaning Reminder
When flashes on the display after cooking
session, the appliance reminds you to clean it
with pyrolytic cleaning. You can turn off the
66 ENGLISH
.
.
.
Duration
1 h
1 h 30 min
3 h
.
reminder in the submenu: Settings. Refer to
"Daily use" chapter, Changing: Settings.
11.6 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Fully open the door.
2. Press the clamping levers
door hinges.
A
3. Close the oven door to the first opening
position (at approximate angle: 70°).
4. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
5. Put the door with the outer side down on
a soft cloth on a stable surface.
6. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
7. Pull the door trim to the front to remove it.
on the two
A
on the top edge of
1