GE AJCM 08 ACD Manual De Instrucciones página 20

Installation Instructions
WINDOW INSTALLATION--OPTIONAL (cont.)
[2] INSTALL CASE IN WINDOW
Peel off the backing from the bottom window
gasket.
Place the gasket on the stool and over the
brackets, even with the rear edge, sticky
side down.
I1 1
I
Bottomwindowgasket
re] carefully slide the empty case into the window
until the holes in the case line up with the holes
in the panel angles.
Case holes
_ix,
[
NOTES:
• The case should have a 1/8" minimum tilt toward
the outside.
• Besure the seal gasket and panel gaskets remain
in position and do not roll with the case.
r_ Lower the window so it fits behind the panel tabs.
Insert the 4 type A screws through the holes in the
case and into the panel angles, 2 on each side.
I
r
•. [-
_Case
r_ With the window closed, mark where the window
sash meets the case.
r_ Peel off the backing from the case top gasket.
r_ Hold on to the case, open the window and place
the gasket along the mark on the case.
Putthe gasket o n
top of the case
wherethe window
will close.
Place the vinyl window gasket over the case top
gasket. Insert the panel tabs through the slits in
the gasket. Cut the gasket on each side to the width
of the window.
Panel
Vinylwindowgasket
[T1
Close the window tightly on the vinyl gasket.
Bend the gasket forward to expose the panel tabs.
Drill pilot holes into the window sash.
__ Attachthe paneltab
to the windowon eachside
w_i_eD screw.
20