Le Chai LBN458POP Manual Del Usuario página 130

POWER
To turn the appliance off, press and hold the key 1 for 5 seconds until temperature display goes out. To
turn the appliance on, press and hold the key 1 for 1 second until temperature display lights up.
NOTE: Pressing the key once can switch off the audible alarm when the alarm is on.
UP
To increase (warm) the set temperature by 1°C or 1ºF.
DOWN
To decrease (cool) the set temperature by 1°C or 1ºF.
LIGHT
To turn the interior light on/off, lightly touch and hold the LIGHT key for 5 seconds. The interior light
indicator will light up or go out to confirm the selection.
The interior light indicator is the dot at the bottom right of the display.
DISPLAY
Display the digital temperature and service indicators. Part 4 is for the UPPER temperature zone and 5
is for the LOWER temperature zone.
Setting the Temperature Control
When the unit is plugged in for the first time, the unit will power up automatically to the preset defaults.
The preset temperature of single zone units at the factory is 12ºC (54ºF).
The preset temperature of dual zone units at the factory for UPPER temperature zone is 8ºC (46ºF) and
for LOWER temperature zone is 12ºC (54ºF).
You can touch the left side UP and DOWN keys to control the internal temperature of the UPPER
temperature zone and touch the right side UP and DOWN keys to control the internal temperature of
the LOWER temperature zone. When you touch either key at the first time, the display will show the
last temperature set previously.
IMPORTANT: The temperature set for the LOWER temperature zone must always be just as high as or
higher than that in the UPPER temperature zone.
The temperature that you desire to set will increase 1ºC or 1ºF if you press the UP key once, on the
contrary the temperature will decrease 1ºC or 1ºF if you press the DOWN key once. The display
flashes while you make the setting.
After the temperature has been set, the display shows the current inner temperature of the particular
temperature zone.
To view the set temperature at any time, press the UP or DOWN key, the set temperature will
temporarily flash in the display for 5 seconds. Then the display shows the current inner temperature
again.
SETTINGS MODE
Certain settings on the wine cellar can only be selected in settings mode. At the same time in settings
mode only the UP and DOWN keys of lower zone are valid for dual zone and three zone units.
ºF/ºC Selection
Lightly touch and hold the UP key for 5 seconds.
▪
Use the UP and DOWN keys to select the temperature display setting in Fahrenheit or Celsius degree.
▪
Touch the POWER key to confirm your selection.
▪
Touch and hold the UP key for 5 seconds to leave settings mode. Otherwise the appliance exits
▪
settings mode automatically after approximately one minute.
Display Brightness
Lightly touch and hold the UP key for 5 seconds and then touch the POWER key once.
▪
Use the UP and DOWN keys to select the brightness of the display. The factory default setting is d1.
▪
d1: dimmest setting
d2: medium setting
EN-130