Publicidad
Idiomas disponibles
Idiomas disponibles
Regulator (only for authorized technicians)
LPG - NG, NG – LPG conversions;
Figure 7
Figure 7.4
When you desire to convert the oven burner,
you should first remove the oven door (See
Cleaning and maintenance).
Remove the screws at the marked points.
This part is used in some countries or regions.
If the regulator is mounted on the product, do not
remove it and do not play with its adjustment.
This device is fixed to prevent any failures arising from
high gas pressure, so only authorized technicians
should perform any kind of operation on it.
In case of conversion from LPG to NG, you are not
required to remove the part.
Figure 7.1
Remove the burner cover and burner as shown in the Figure 7.
Remove the injector by help of 7's socket screw driver as shown
in the Figure 7.1.
Fix the injector (D) you want to convert as shown in the Figure
7.2 (see Table 1 at the end of this manual).
Put the burner in place again as shown in the Figure 7.3.
Upon completion of the conversion, then burn the burners in
order and remove the switch on the control panel and adjust the
low flame length by tightening or untightening the screw on the
gas valve (7.4) or inside the valve shaft.
Figure 7.2
13
Figure 7.3
Figure 8
V.1
Publicidad
