Publicidad
Idiomas disponibles
Idiomas disponibles
FAN INSTALLATION
1. Remove the canopy bottom cover (C) from
the canopy (B) by turning the canopy bottom
cover (C) counterclockwise.
Remove the mounting bracket (A) from the
canopy (B) by removing the non-slotted
canopy mounting screw from the bottom of
the canopy (B) and loosening the slotted
canopy mounting screw a half turn from the
screw head. Next, turn the canopy (B)
counterclockwise to remove the mounting
bracket (A) from the canopy (B).
2. Pass the 120 volt supply wires through the
center hole in the mounting bracket (A).
Install the mounting bracket (A) to the outlet
box with the screws and washers provided
with your outlet box. Securely tighten the two
mounting screws.
NOTE: It is very important you use the
proper hardware when installing the mounting
bracket (A) as this will support the fan.
3. Loosen two set screws located in the hanger
ball by using the hex wrench (EE ) provided.
Lower the hanger ball and remove the cross
pin. Remove the hanger ball from the downrod
assembly (D).
Remove the cotter pin and clevis pin, and
loosen the two collar set screws from the
motor collar.
Hardware Used
EE
Hex Wrench
1
Canopy Mounting
Screw
2
Outlet Box
3
Cross Pin
Set Screw
Cotter Pin
Set Screw
8
Canopy Mounting
Screw
Washers
Outlet Box
Screws
Hanger Ball
Set Screw
Collar
Set Screw
Clevis Pin
Publicidad
