Publicidad
Idiomas disponibles
Idiomas disponibles
FAN INSTALLATION
4. Carefully feed the motor wires and safety
cable up through the downrod (D). Thread
the downrod (D) into the collar.
Align the holes and replace the clevis pin
and cotter pin. Tighten the two collar set
screws.
5. Slip coupling cover (E), canopy bottom cover
(C), and canopy (B) onto the downrod (D).
Carefully reinstall the hanger ball onto the
downrod (D).
Tighten the two set screws by using the hex
wrench (EE) provided.
Make sure the cross pin is in the correct
position, the set screws are tightened and
wires are not twisted.
Hardware Used
EE
Hex Wrench
6. Remove two screws from two upper sides of
hanger ball. Carefully lift the fan motor
assembly up to the mounting bracket (A) and
seat the hanger ball/downrod assembly (D)
in the mounting bracket (A) socket. Securely
tighten two screws previously removed on
the hanger ball.
Secure the wood screw, lock washer and flat
washer (DD) to the building structure that
independent to the outlet box. Loop the
safety cable around the wood screw that was
just attached to ceiling joist. Tighten the
wood screw. The safety cable should be in a
stress-free state after installation.
Hardware Used
Safety Cable Screw,
DD
Lock Washer and
Flat Washer
4
Cotter Pin
Set Screw
5
Cross Pin
Set Screw
6
Screw
Hanger Ball
x 1
9
Safety Cable
Collar
Set Screw
Clevis Pin
Hanger Ball
Set Screw
Safety
Cable
Screw
Publicidad
