Publicidad
en Troubleshooting
Fault
Water is dripping from the
brewing unit.
There is water under the cup
stand.
Information on display panel
Fault
No LED is lit.
All LEDs flashing.
LED
lights up.
LED
lights up even
though there is enough wa-
ter in the water tank.
LED
lights up.
34
Cause
T DISC is damaged, leaking
or not correctly pierced.
The piercing unit is not inser-
ted correctly.
Condensation has formed
due to technical reasons.
Cause
Appliance is in idle mode.
Voltage in the house system
is incorrect.
Water tank has not been suf-
ficiently filled.
Float is stuck in the water
tank.
Water tank is wrongly inser-
ted.
Build-up of limescale in the
appliance.
troubleshooting
Use a new T DISC.
▶
Only use T DISCs once.
▶
Wait until the brewing process has
1.
come to an end and the appliance
has cooled down.
Remove the T DISC.
2.
Clean the brewing unit.
3.
→ "Cleaning the appliance",
Page 31
Press the piercing unit into the
▶
holder using both thumbs until it
clicks audibly into place.
▶
Remove excess water with a soft
cloth.
troubleshooting
▶
Press
.
Pull out the mains plug and re-insert
1.
it.
If the problem persists for a longer
2.
period, have the voltage of your
property checked by an electrician.
Fill the water tank with fresh, cold
1.
water up to the mark
Insert the water tank.
2.
Descale the appliance.
1.
→ "Descale the appliance",
Page 31
Reach into the water tank and
2.
move the float up and down.
Insert the water tank correctly.
1.
Push the water tank into the appli-
2.
ance until it clicks into place.
▶
Descale the appliance.
→ "Descale the appliance",
Page 31
.
Publicidad
