Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Donotusetemplate supplied tosetthe
rearrail.
8. Makesurethetopedgeof thefrontrailis belowthe
topofthesawtableandthatthefrontrailis not
blocking theendsof themitergaugegrooves.
9. Whenyouaresurethattherearrailis properly
aligned andit is parallel to thetablesurface,
securely tightenrearrailmounting hardware.
BIESEMEYER
EXTENSION
TABLE
ASSEMBLY
Figure
11=6
c
B
A
2,
3,
Place the Biesemeyer extension table assembly (A)
in position between the front and rear rails. Make
sure the edge of the extension table assembly is
flush against the right side of the extension wing
(B). Using a straight edge or level (C) make certain
the extension table is level to the saw table.
Using
a pipe clamp (not supplied) (D) snug up the ends of
rails to hold the extension table in position. It may
be necessary to clamp extension wing (B) and the
extension table (A) together; use two c-clamps
underneath the table surface. See figure 11-6.
Drill four 5/16" holes (E) through extension table
assembly using existing holes in the front and rear
rails. See figure 11-6.
After the holes have been drilled, fasten the front
rail to the extension table using two 5/16-18 x 1-1/2"
flat head screws, 5/16" flat washers, 5/16" lock
washers and 5/16-18 hex nuts. Fasten the rear rail
to the extension table using two 5/16-18 x 1-1/2"
hex head screws, 5/16" flat washers, 5/16" lock
washers and 5/16-18 hex nuts. Make sure the
extension table is still level with the saw table
before securely tightening hardware. Remove all
clamps.
GUIDE TUBE AND SWITCH
ASSEMBLY
Figure
11=7
B
1,
Align the four threaded holes in the bottom of the
guide tube (A) with the four holes in the right side of
the front rail (B). Fasten the guide tube to the front
rail with four 1/4-20 x 1/2" hex head screws and
1/4" lock washers. Do not tighten screws at this
time. See figure 11-7.
Figure
11=8
D
D
2.
Attach switch (C) to the two tapped holes (D) in the
far left bottom of the guide tube with two 1/4-20 x
3/4" hex head screws and 1/4" lock washers.
See figure 11-8.
3.
Make sure the guide tube is parallel to the front rail
before tightening all six screws.
21
Publicidad
