Publicidad
Idiomas disponibles
Idiomas disponibles
Figure
22=2
CLAMP
AND FENCE STOP OPERATION
G
D
MAKE CERTAIN the table saw is disconnected from
the power source when making adjustments.
3,
To rotate to the next positive stop pull plunger out,
rotate miter gauge body then push plunger back in
and continue rotating miter gauge body until it stops
against next positive stop.
4.
To adjust O-degree positive stops, loosen knob, pull
out on plunger and turn miter gauge over.
5.
Loosen the lock nut (D) 3 or 4 turns. See figure 22-2.
6,
Place a square against the guide bar (E) and front
of the miter gauge body (F). Square the miter
gauge body to the guide bar and tighten knob.
See figure 22-1.
7.
Push in plunger and make adjustments to stop
screw (G) so that it touches the plunger, then tight-
en lock nut. See figure 22-2.
8.
Recheck the positive stop angle to the saw blade.
Insert the guide bar into the miter gauge groove
and slide the miter gauge up to the saw blade.
9.
To check, place a square against the saw blade
and miter gauge body. If any more adjustments are
needed repeat steps above.
10. To set both 45-degree positive stops, repeat steps
above.
Figure
23=1
E
B
C
\
D
1,
2,
3,
The stock clamp (A) can be positioned in and out
by loosening the two knobs (B) and sliding the
clamp body in or out. Refighten knobs when at
desired position.
See figure 23-1.
The stock clamp has a quick release allowing you
to quickly position the clamp up or down. To en-
gage quick release press up on trigger (C) and hold.
The clamping pad (D) will fall or it can be lifted. To
release let go of the trigger. Now you can turn knob
(E) to apply clamping pressure.
See figure 23-1.
The fence stop (F) can be repositioned along the
fence by loosening the hex socket head screw (G).
Slide the fence stop to desired position and tighten
hex socket head screw. If the fence stop is not
needed, it can be stored out of the way on the
backside of the fence. See figure 23-1.
33
Publicidad
