Publicidad
Idiomas disponibles
Idiomas disponibles
MITER GAUGE
ASSEMBLY
Figure
13=2
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure
13-1
E
B
2,
3,
Thread elevating rod (A) into the top threaded hole
in the miter gauge body (B). See figure 13-1.
Place clamp assembly (C) on top of the miter
gauge knob (D) and elevating rod. Place two
knobs (E) through the slot in the clamp assembly
and thread one knob into miter gauge knob
and one into the elevating rod. Position clamp
assembly as shown and tighten both knobs.
See figure 13-1.
Place one M5 flat washer onto one M5 x 20mm hex
socket head screw. Thread one M5 square nut
onto the hex socket head screw until the screw is
flush with the back of the square nut. Repeat this
for one more flat washer, head socket head screw
and square nut.
H
4,
5,
6,
Slide both of the square nuts with hex socket head
screw and flat washer (F) into the lower T-slot (G)
of the cross cut fence (H). See figure 13-2.
Place the thread section of the hex socket head
screws into the grooves (I) of the miter gauge body.
Make sure the flat washers are against the heads
of the hex socket head screws.
See figure 13-2.
Position the cross cut fence so that no part of the
fence is in the path of the saw blade. Allow the
cross cut fence to rest on the saw table and
securely tighten both hex socket head screws.
Figure
13=3
7,
8,
9.
Place one M5 flat washer onto one M5 x 20mm hex
socket head screw (J). Place this through the hole
in the top of the depth stop (K). Thread one M5
square nut onto the hex socket head screw until the
tip of the screw is flush with the back of the square
nut. See figure 13-3.
Slide the square nut and depth stop into the top
T-slot (L) of the cross cut fence.
See figure 13-3.
Position depth stop as desired and tighten the hex
socket head screw.
Note: Storage hooks for crosscut fence are located
under motor cover.
24
Publicidad
