Publicidad
Idiomas disponibles
Idiomas disponibles
LUBRiCATiON
The table saw has sealed lubricated bearings in the
motor housing that do not require any additional lubrica-
tion from the operator.
CLEANING
With the table saw unplugged, blow off motor with low-
pressure air to remove dust or dirt. Air pressure above
50 R S. I. should not be used as high-pressured air
may damage insulation.
The operator should always
wear eye protection when using compressed air.
Do not allow chips and dust to accumulate under table
saw. Keep area clean and in safe order.
CAUTION: DO NOT USE FLAMMABLE
MATERIALS
to clean tame saw.
Only trained personnel should perform repairs to the
table saw. Contact your nearest Sears Service Center
for authorized service. Unauthorized
repairs or replace-
ment with non-factory parts could cause serious injury
to the operator and damage to the table saw.
39
Publicidad
