Publicidad
Idiomas disponibles
Idiomas disponibles
Auto Starting/Stopping the Dust Extractor
— Once the plug of the dust extractor has been inserted into the primary pow-
er source, the switch of the dust extractor has been set to Power Tool Acti-
vation Mode, the Plug 4 of the Receiver 1 has been inserted into the plug
socket of the dust extractor and both the Auto-Start Remote 5 and Receiver
1 have been successfully paired, your auto start system is ready to be used.
— Ensure that the Auto-Start Remote 5 is flush and snug against the mount-
ing surface of the cordless tool by adjusting the position on the supplied
Attachment Band 10.
— Insert the extraction hose into the dust extractor attachment of the cord-
less tool.
— Once the cordless power tool is turned on/off, a start/stop signal is sent
from the Auto-Start Remote 5 to the Receiver 1 and the corresponding dust
extractor is turned on/off.
Utilizing Manual Mode
— Briefly press the Start/Stop Button 7 on the Auto-Start Remote 5. The
dust extractor will be switched on.
— To switch the dust extractor off, briefly press the Start/Stop Button 7 on
the Auto-Start Remote 5 again.
Note: If the dust extractor is switched off using the Start/Stop Button 7 on
the Auto-Start Remote 5, the dust extractor will automatically switch on once
the Auto-Start Remote 5 detects the vibrations of the activated cordless tool.
160992A8R3 GCA30-42K 202404.indd 19
19
4/1/24 3:45 PM
Publicidad
