Publicidad
Idiomas disponibles
Idiomas disponibles
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
GCA30-42 complies with ISED RSS-102 radiation exposure limits set forth
for an uncontrolled environment. The GCA30-42 complies with the safety
requirements for RF exposure in accordance with RSS-102 Issue 5 section
2.5.1 for portable (≤20 cm) use conditions.
HVIN: GCA30-42
Intended Use
This autostart system is an attachment that is compatible with Bosch dust
extractors. It is designed to automatically start and stop the connected dust
extractor when the cordless power tool is turned on/off.
When the cordless power tool is turned on/off, the vibration detection sen-
sor inside the GCT30-42 Auto-Start Remote transfers a start/stop signal to
the GCA30-42 receiver. When the GCA30-42 receiver receives the the start/
stop signal, the corresponding dust extractor will automatically start/stop.
Refer to the operating instructions for the Auto-Start remote GCT30-42 or
the dust extractor used for more information.
SAVE THESE INSTRUCTIONS
6
160992A8R3 GCA30-42K 202404.indd 6
4/1/24 3:45 PM
Publicidad
