GE 20 Manual Del Propietario E Instalación página 17

Installation Instructions
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below ¢o0°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (:37°C)because it will not perform
properly.
Install it on c] floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clec]rc]ncesfor ease of instc]llc]tion,
proper air circulation and plumbing and electrical
connections.
Standard Depth
Models
Sides 1/8" (3 mm)
Top 1" (25 mm)
Back 1" (25 mm)
REMOVETOP CAP{onsomemodels)
• IMPORTANTNOTE:This refrigerator is 34-i/2" deep.
Doors and passageways leading to the installation
location must be at least 36" wide in order to leave
the doors and handles attached to the refrigerator
while transporting it into the installation location.
If passageways are less than 36", the refrigerator
doors and handles can easily be scratched and
damaged. The top cap and doors can be removed
to allow the refrigerator to be safely moved indoors.
Start with Step A.
• If it is not necessary to remove doors, skip Step A.
Leave tape and all packaging on doors until the
refrigerator is in the final location.
• SKID REMOVAL: Tilt refrigerator to each side to
remove skid.
• NOTE:Use a padded hand truck to move this
refrigerator. Place the refrigerator on the hand truck
with a side against the truck. We strongly recommend
that TWO PEOPLEmove and complete this installation.
[] Locate and remove the two Phillips head screws on
the top of the refrigerator. Remove the two screws
on each side tit the rear of the top cup. Lift off and
remove top cap.
rB1 Remove the fresh-food door. Refer to Steps i through
:3of "Reversing the Door Swing" section.
F_ Remove the bottom freezer drawer. Refer to
"Removing Freezer Drawer" section.
[D1 Move refrigerator to the instc]llc]tionlocution.
REMOVE TOP CAP {cont.)Ion some models)
REINSTALL DOORS, DRAWERS AND TOP CAP
rE1 Carefully lower the door onto the center hinge.
Reinstall top hinge. NOTE:Ensure the door is properly
aligned to the case top to (]void readjustment of the
door during top cup reinstc]lk]tion.
FF1 Place cup over the top of the refrigerator. Reinstall
the original screws in the top and buck of the cup.
[] Reinstall the bottom freezer drawer. Refer to
"Replacing the Freezer Drawer" section.
A
Top Hinge B
IT] CONNECTING THE REFRIGERATOR
TO THE HOUSE WATER LINE
{icemaker and dispenser models}
A cold water supply is required for automatic
icemc]ker operation. If there is not c]cold water
supply, you will need to provide one. See Installing
the Water Line section.
NOTES:
• Before making the connection to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet.
If your refrigerator does not have c] water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's water valve. Install it in the water line
near the refrigerator. If using GESmc]rtConnectT"
Refrigerator Tubing Kit, you will need tin additional
tube (WX08X10002) to connect the filter. Do not cut
plastic tube to install filter.
17