GE 20 Manual Del Propietario E Instalación página 18

Installation Instructions
INSTALLING THE REFRIGERATOR
{cont.}
ril
CONNECTING THE REFRIGERATOR TO
THE HOUSE WATER LINE
(cont.)
j_ If you are using copper tubing, place a
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If gou are using the GE SmartConnect'"
tubing, the nuts are already assembled to
the tubing.
[] If gou are using copper tubing, insert
the end of the tubing into the refrigerator
connection, at the back of the refrigerator,
as far as possible. While holding the tubing,
tighten the fitting.
If gou are using GE SmartConnect'" tubing,
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression
nut until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
may cause leaks.
Fasten the tubing into the clamp provided to
hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like
the connection on gour refrigerator.
Icemaker-Readg models
Tubing ._
Clamp
!/4"
Compression
Nut _
Ferrule /_-_'
(sleeve)_J_
Refringer_i t o°r j_
!/4" Copper
SmartConnecf"
Tubing
Icemaker-lnstalled Models
Ferrule !/4"
Refrigerator (sleeve) Compression
Connection
SmartConnectT M
Tubing
Tubing Clamp
1/4" Tubing
18
[_ TURN ON THE WATER SUPPLY
(icemaker and dispenser models)
Turn the water on at the shutoff valve (house
water supply) and check for any leaks.
[] PLUG IN THE REFRIGERATOR
On models with an icemaker, before plugging in
the refrigerator, make sure the icemaker power
switch is set to the 0 (off) position.
See the grounding information attached to the
power cord.
[_[] PUTTHE REFRIGERATOR IN PLACE
Move the refrigerator to its final location.
LEVEL THE REFRIGERATOR
Adjustable legs at the front corners of the
refrigerator should be set so the refrigerator is
firmly positioned on the floor, and the front is
raised just enough that the door closes easily
when opened about halfway.
To adjust the leveling legs, turn the legs
clockwise to raise the refrigerator,
counterclockwise to lower it.