GE 20 Manual Del Propietario E Instalación página 26

Installation Instructions
REVERSING THE DOOR SWING
{cont.}
I-_ REHANG REFRIGERATOR DOOR
r_ Lower the refrigerator door onto the center
hinge pin. Ensure that the plastic hinge pin
thimble is on the center hinge pin or inside
door hinge pin hole located in the bottom
of the door.
r_ Insert the door thimble into the hinge hole
on top of the refrigerator door and then
insert the top hinge pin. Make sure the door
is aligned with the cabinet. Attach the hinge
to the top of the cabinet Iooselg with the bolts.
r_ MQke sure the gasket on the door is flush
against the cabinet and is not folded. Support
the door on the handle side and make sure the
door is straight and the gap between the doors
is even (]cross the front. While holding the door
in place, tighten the top hinge bolts. Replace
the hinge cover.
r_ INSTALL THE LOGO BADGE
Remove the adhesive backing paper
Qnd Qlign the pins on the back of the bQdge
with the holes in the door. Applg pressure to
the badge to ensure it sticks to the door.
26