GE 20 Manual Del Propietario E Instalación página 4

About the controls with temperature settings.
(onsome models)
[] TEMPERATURE SET
WARMER _ WARNER
I
_ L O_ F R_°mmended 37_ F Rec°mmended
[]
[] []
[EE
Hold 3 seconds to reset Hold 3 seconds
(onsome models)
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
The temperature controls are preset in the factory at 37°F for the refrigerator
compartment and O°F for the freezer compartment. Allow 24 hours for the temperature
to stabilize to the preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature mabt varbt slightlbt
from the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
4
Chonging the Temperature
For Controls-on-the-Door Models:
To change the temperature, press and release the
WARMERor COLDERpad. The ACTUALTEMPlight
will come on and the display will show the actual
temperature. To change the temperature, tap either
the WARMER or COLDERpad until the desired
temperature is displayed.
For Controls Inside the Refrigerator:
Opening the door displags the actual temperature.
To change the temperature, press either the
WARMERor COLDERtouch pads until the
desired temperature is displayed.
Once the desired temperature has been set,
the temperature display will return to the actual
refrigerator and freezer temperatures after 5 seconds.
Severaladjustments may be required.
Eachtime gou adjust controls, allow 2/4hours for the
refrigerator to reach the temperature you have set.
To turn the cooling system off, tap the WARMERpad
for either the refrigerator or the freezer until the
displag shows OFF.To turn the unit back an, press
the COLDERpad for either the refrigerator or freezer.
Then press the COLDERpad again and it will go to
the preset points of O°Ffor the freezer and 37°Ffor
the refrigerator. Setting either or both controls to
OFFstops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power
to the refrigerator.