Servicing Instructions - haacon SX Serie Instrucciones De Uso

After every operation switch the gear to low gear. Always
place the crank handle in the holder provided for it.
After uncoupling the foot must be in it's neutral position.
Do not move the trailer once settled.
To load the supported trailer vehicle
If the appropriate safety regulations are observed, the supported trailer
vehicle may be
z loaded using a crane and
z driven on with a forklift truck
Do not exceed the centre of gravity, otherwise the trailer
vehicle will tip over.
7. TESTING
The spindle supports must be tested at least once a year by an author-
ised person per TRBS 1203 (Technical expert).
Technical experts are persons, who have sufficient knowledge based
on their specialist training and experience, in the areas of winches, lift
GB
and pull systems and the relevant official occupational health and safety
rules, accident prevention regulations, guidelines and generally accept-
ed engineering rules (e.g. EN standards), to evaluate the operational
safety of winches, and lift and pull systems. Technical experts are to be
nominated by the operator of the equipment. Performance of the annual
occupational safety inspection as well as the training required to obtain
the aforementioned knowledge and skills can be provided by haacon
hebetechnik.
8. SERVIcE
Only allow the device to be serviced and repaired by trained personnel.
Only use genuine spare parts for repair work.
Do not make any modifications or additions to parts with a safety function.
Additional mountings must not adversely affect safety.
The relevant regulations apply.
Only carry out repair work when wearing safety clothing (gloves, safety
shoes, safety goggles, etc.).
Tighten screws and nuts to the specified torque.
Test the function after repair.
Cleaning
Clean the support device as part of your normal vehicle care.
Do not spray high pressure cleaner jets direct at
the support device.

Servicing instructions

Servicing work
Conduct a visual inspection of the
support device for signs of cracks an
deformation
Grease spindle and spindle nut (1)
Molibdenli Gres 2, or comparable,
e.g. Energrease L 21M
Quantity ~ 200 g
Grease gear (2)
Standard lubricating grease with
lithium soap basis
Professional inspection according to
DGUV-V 54
1
Servicing interval
Each time you use the support
device; repair the support device
immediately if it is damaged.
Every year
2
2
– 12 –