User Groups; Safety Instructions - haacon SX Serie Instrucciones De Uso

1. uSER GROupS

Duties
Operator Operation,
visual inspection
Specialist Assembly, disas-
personnel sembly, repair,
maintenance
Tests

2. SAFETy INSTRucTIONS

The safety regulations set out in the appropriate points in the operating
manual must be observed for operating, servicing, installing and repai-
ring the support device. The safety regulations for the tractor and trailer
vehicle are also valid.
After its careful installation check the function of the support device. If it
is not used for the purpose for which it is designed, the support device
may constitute considerable potential danger.
Riding with damaged spindle support device is forbidden.
Observe the regulations for road traffic and the accident prevention
regulations issued by the professional associations, in particular
z The operating manual for the tractor vehicle
z The operating manual for the trailer vehicle
z DGUV-V 54 „Accident Prevention Regulations for Winches, Lifting and
Towing Equipment"
z DGUV-V 70 „Accident Prevention Regulations for Motor Vehicles"
z DGUV-V 68 „Industrial Trucks"
Ask the manufacturer about the device's suitability for other applications.
– Observe lifting device and load during all movements.
– Transport device protected against impacts and shocks, falling over or
toppling.
– Maximum load does not exceed!
where a failure to observe instructions would result in
special danger, these instructions are marked with the
warning symbol shown here.
Qualifications
Instruction by means of the operating
instructions; Authorised person
Mechanic
Authorised person per TRBS-1203
(Technical expert)
Normal use
The haacon spindle support device is designed for mounting on a trailer
vehicle.
It serves to support the uncoupled trailer, idem for levelling while cou-
pling the trailer.
The support device may only be commissioned in accordance with these
operating instructions and the operating instructions for the towing and
towed vehicle.
It must not be brought into circulation until it has been established that
the trailer vehicle with the support device complies with the national
regulations for road traffic. D'ont drive with damaged spindle support.
– Only operate following the instructions
– Only use when in perfect working order.
– Only allow to be operated by personnel instructed on how to do so.
– Only use on a substrate with sufficient load-bearing capacity.
Safe working practices
– First read the operating instructions.
– Always be conscious of safety and hazards when working.
– Immediately report any damage or defects to the person in charge.
– Repair equipment first before continuing work!
Do not:
– Overload (–> technical data, type plate, payload plate)
– Persons dwelling under the suspended load.
Organisational measures
– Keep parking area free of persons and hindrances.
– Ensure that these operating instructions are always at hand.
– Ensure that only trained personnel work with the equipment .
– Check at regular intervals whether it is being used in a safety and
hazard conscious manner.
Further regulations to be observed are
– German Industrial Health and Safety Ordinance.
– Country-specific regulations.
– German Accident prevention regulations.
– 9 –
GB