Turning The Power On; Standby Mode - Aiwa XP-V730C Manual De Instrucciones

Tabla de contenido

Publicidad

sSTOP/OFF/CHARGE
ePLAY/PAUSE
18
HOLD switch
Release HOLD. → a
When not using the unit, set HOLD to the hold
position. → b
Accidentally pressed buttons will not function.
If ePLAY/PAUSE is pressed while HOLD is set
to the HOLD position, "HOLd" flashes in the display.

Turning the power on

Press ePLAY/PAUSE.
Power is turned on and playback starts.
Note
"Err" appears on the display in the following cases:
– When you try to play the unit without a disc in the disc
compartment.
– When you play a disc placed upside-down or a defective
disc.

Standby mode

When an operation finishes, the unit goes into
standby mode until the auto power off function
automatically turns off the power.
To enter standby mode, press e PLAY/PAUSE
to start playback, then press sSTOP/OFF/CHARGE.

Publicidad

Tabla de contenido
loading

Tabla de contenido