Bead Breaking - CEMB SM628TI Manual De Uso

The TPMS device (optional accessory) can be used to check the proper opera-
tion of pressure sensor.
Remove the old weights from the rim before starting work operations.

9.3. BEAD BREAKING

Before bead breaking operation, completely close the turntable (locking wedges
towards the centre) (A, Fig.14a), keeping your hands away from moving parts.
- Press pedal
guration, the jaws are completely closed. (Fig. 14a).
- Remove the internal valve to fully deflate the
tyre (Fig. 14b).
- Adjust the rim rest depending on wheel diameter
- Adjust the inclination of the blade according to the
wheel width by means of the pin in order to obtain a
better inclination between the blade and the tyre: in
position 1 in fig.15 for low width tyres, in position 2
for high width tyres
- Position the wheel as shown in fig.16 and move
the bead breaker shoe near the rim edge.
32
WARNING
WARNING
WARNING
14a
A
and bring it into completely lowered configuration. In this confi-
1
A
2
A
User's manual
14b
15