Publicidad
Idiomas disponibles
Idiomas disponibles
T60088 & T60288 Series Installation
Showerhead Installation
2
(For Tub Spout installation refer to the installation guide provided with your tub spout)
Apply plumber tape to threads on brass adapter
(1). Install adapter so that it extends beyond
the finished wall 1-1/4" to 1-1/2". Ensure that
O-Rings (2) are installed properly into grooves
on adapter. For an addtional 1-3/4" of depth,
order extension RP101285.
Slide shower flange (3) over shower arm (4).
Mounting Bracket Installation
3
Place bracket (1) against finished wall so that the
holes in legs of bracket align with threaded holes
on the rough.
Use two long screws provided to secure the
91834
Rev. D
3
4
6
1
1
2
5
Install shower arm (4) onto brass adapter (1),
and secure with set screw (5) on side of shower
arm. Slide flange (3) until it is flat against the
finished wall.
Apply plumber tape to threads on shower arm
(4). Thread showerhead (6) onto shower arm.
Do not overtighten showerhead.
bracket to the rough. Do not overtighten screws.
Ensure that the bracket lays flat against the
finished wall.
4
Publicidad
