Publicidad
Idiomas disponibles
Idiomas disponibles
Valve Trim Installation
4
A.
1
Slide O-ring (1) over cartridge and the bonnet
nut (2). The O-ring, which acts as a spacer to
steady the sleeve, should rest behind the
bonnet nut.
Note: Depending on location of valve within the
wall and wall thickness, an optional extension kit
may be needed. RP91022▲ will provide up to
1-3/4" of extension.
C.
4
6
Secure the escutcheon (4) to the bracket (5)
with the 2 screws provided (6).
Do not overtighten escutcheon screws.
T60088 & T60288 Series Installation
2
5
B.
3
Slide the sleeve (3) over the cartridge, body and
O-ring (1). Ensure sleeve is properly positioned
over the front of cartridge.
D.
8
Slide screw cover (7) over trim sleeve (3) and
press firmly until the cover is flush with escutcheon.
O-ring will hold screw cover in place.
Before installing volume control handle (8),
ensure valve is in the full cold position (clockwise).
Orient handle so the lever is pointing downward
(6 o'clock position) and press handle onto
cartridge. Secure handle with set screw provided
(9) and press button (10) into hole.
5
1
7
3
9
10
91834
Rev. D
Publicidad
