Bestron DWJ5280 Manual De Instrucciones página 21

OPERATION - Fitting the accessories
All accessory parts are provided with a locking mechanism. To this end, the locking plug is to be "clicked" into
the appropriate opening. To release the accessory, just press the locking part and pull it out. Should this prove
to be difficult we would recommend that you coat the parts with a little grease.
WARNING:
• The accessories get hot when cleaning for a long time! You should be aware of this, especially when
changing accessories while cleaning.
ACCESSORIES - Floor brush
For cleaning larger areas such as carpets or floor coverings. The floor nozzle can be used with or without cloth.
However, sensitive surfaces should be cleaned with cloth. Press the spring clips down to fit the cloth and then
release the spring clips (see figure 3).
ACCESSORIES - Curved nozzle (18)
The angled steam nozzle can be used to clean in corners and difficult places, such as smaller spaces as toilets
and wash basins.
ACCESSORIES - Round brushes (15 & 16)
The round-brushes can be used to clean very dirty areas or uneven hard surfaces, for example such as
pointing.
WARNING:
• Sensitive surfaces: Do not clean them with the nylon nozzle. This could damage the surface.
ACCESSORIES - Window wiper (14)
The window wiper can be used to clean large glass surfaces such as window panels and mirrors.
WARNING:
• Warm up such glass panels in winter by pre-steaming at a distance of 30 cm with a little steam before
starting to clean.
OPERATION - Steam cleaning
The steam gun is provided with a kids-safety button (12). If the lock is pushed up to the full extent the steam
switch will be locked. The lock prevents unintentional discharge of steam when the appliance is not being used
properly by other persons or children (see figure 4).
1. Fill the water tank with water (see 'Filling the tank with water').
2. Fit the appropriate accessory (see 'Fitting the accessories').
3. Put the plug into the wall socket
4. Press the on/off switch (8).
5. The appliance will heat up (± 10 minutes), the power light (6) and steam control light (7) illuminates.
6. The appliance is ready for use once the steam control light extinguishes.
7. During cleaning the steam control light illuminates and extinguishes variable. This is normal because the
appliance frequently heats up automatically in the meantime. Stop with cleaning at this moment to prevent hot
water will come out. So the appliance can build up the pressure (takes 40 seconds max.).
8. Unlock the steam gun by pressing the kids safety button (see figure 4). Press the steam switch (11) on the
steam gun. Steam will escape as long as the steam switch is pressed down. Just release the steam switch to
stop.
9. The amount of steam can be adjusted as required by means of the steam switch.
- Less steam: Just press down steam switch slightly
- More steam: Completely press down steam switch.
10. Move the appliance backwards and forwards over the object to clean it. For optimum results keep the
cloud of steam close to the surface; this will offer the steam most chance to penetrate the dirt.
11. When you have finished, put the appliance down where the steam will not contact any surfaces and allow
the last steam to escape.
12. Remove the plug from the wall socket and allow the appliance to cool down completely.
21 21
EN EN