Publicidad
Idiomas disponibles
Idiomas disponibles
4.4.1 - Autolearning of the travel stroke and main parameters
1. Unlock the gear motors, bring the doors to approximately half their travel and lock the gear motors again.
2. To start the learning procedure, press and hold the
(UP) and
(MENU) buttons at the same time; after approximately two seconds the leaf relating
to M1 begins to open slowly; the display shows
!
WARNING
If the leaf moves in the closing direction, stop the movement by pressing the
(DOWN-RADIO) button; press the
direction of movement reversed.
3. Once the maximum opening point has been reached, the door relating to M1 stops; the leaf relating to
M2 slowly starts to open; the display shows
!
WARNING
If the leaf moves in the closing direction, stop the movement by pressing the
(DOWN-RADIO) button; press the
direction of movement reversed.
4. Once the maximum opening point has been reached, the leaf relating to M2 stops; after approximately
2 seconds it slowly starts to close; the display shows
5. The auto-learning operation of the leaf travel relative to M2 ends when the
closing point is reached. After approximately two seconds the leaf relating to M1 slowly begins to
close; the display shows
6.The auto-learning operation of the leaf travel relative to M1 ends when the closing point is reached.
The auto-learning operations are completed.
!
WARNING
The travel auto-learning operations must be fully and correctly completed before
putting the equipment into operation; their interruption is only possible by intervening on the safety
devices (EDGE/STOP, PH2, PH1) or by cutting off power to the control unit.
7. After having correctly completed the travel auto-learning procedures, perform a few complete opening and closing manoeuvres of
the gate to check its correct functioning.
After having successfully completed the auto-learning it will be possible to modify the operating parameters by accessing the
or
(paragraph 5).
4.4.2 - Autolearning of the travel stroke and main parameters, with customised decelerations
The default low speed travel length is 20% of the total travel length. It is possible to change the default value of the travel width
performed at low speed, both in opening and closing, by acting on the
(customised). See paragraph 5.1
1. Unlock the gear motors, bring the doors to approximately half their travel and lock the gear motors again.
2. To start the learning procedure, simultaneously press and hold
the
(UP) and
(MENU) buttons for approximately two seconds; after about two seconds the leaf
relating to M1 begins to open slowly; the display shows
!
WARNING
If the leaf moves in the closing direction, stop the movement by pressing the
(DOWN-RADIO) button; press the
of movement reversed.
3. Once the maximum opening point has been reached, the leaf relating to M1 stops; the leaf relating to
M2 starts to open slowly; The display shows
WARNING
!
If the leaf moves in the closing direction, stop the movement by pressing the
(DOWN-RADIO) button; press the
of movement reversed.
4. Once the maximum opening point has been reached, the leaf relating to M2 stops; after approximately
2 seconds it slowly starts to close; the display shows
5. Having reached the point where it is necessary to start the slowing down phase (closing), press the
button
(SBS); the display shows
(SBS) button to resume the learning procedure with the
.
(SBS) button to resume the learning procedure with the
(SBS) button to resume the learning procedure with the direction
.
(SBS) button to resume the learning procedure with the direction
.
parameter in the
.
EN
M1
M2
M1
M2
M1
M2
M1
M2
M1
M2
and/
menu by selecting P
M1
M2
M1
M2
M1
M2
M1
M2
11
Publicidad
