Bosch BDS3210 Instrucciones De Montaje página 8

English – 2
Installation positions
➀
The 1-arm socket can be mounted at three different posi-
tions on the handlebars:
– In front of the handlebars ➀
– Over the stem ➁
– In the triangle between the stem and handlebar ➂
Note: In order to ensure clean cable routing, the appropriate
display mount must be used for each of the three different
positions: The BDS3210 display mount for in front of the
handlebars (electrical connections at the rear); the
BDS3250 display mount for over the stem or in the triangle
between the stem and handlebar (electrical connections at
the front).
If you want to change the installation position and you have
the correct display mount (9), you must first remove the 1-
arm socket (6) and re-mount it afterwards.
Note: Please be aware that there are two different handlebar
diameters (31.8 mm and 35 mm). Your bicycle retailer will
help you to select the correct components.
Mounting the display mount
(9)
(2)
(11)
Insert the display mount (9) into the adapter tray (2). En-
sure that it is in the required installation position. Secure the
display mount (9) from below using the screws (12). When
doing so, be aware of the torque specified on the adapter
tray (2).
Connect the connection cables (11) that come out of the
drive unit and the control unit. It does not matter which
cable is connected to which connection for the functions to
work. When connecting the cables, ensure that the markings
on the connector and on the cable match.
Pay attention to the colour coding of the con-
nector and the port when inserting the cable.
M 275 007 3S1 | (12.04.2023)
Securing on the handlebars
➁ ➂
(3)
(5)
Note: The display holder must only be secured in the cyl-
indrical area of the handlebars and not in the tapered area.
To align an on-board computer in the centre, the handlebars
must have a cylindrical area of at least 90 mm in width.
Open the clamp and bring the 1-arm socket (6), together
with the round rubber spacer (5), into the required position.
Gently tighten the clamp screw (4) so that the 1-arm
socket (6) can still move.
Adjust the tilt for the display mount by loosening and tight-
ening the screw (7). Ideally, the inclination should be adjus-
ted without the on-board computer.
In the connection between the 1-arm socket (6) and the ad-
apter tray, there are interlocking teeth, which means that it
is only possible to align the adapter tray in predefined posi-
tions. Before tightening the screw (7), make sure that the
teeth engage in one another correctly. In addition, be aware
of the torque specified on the 1-arm socket (6).
Bring the 1-arm socket (6) into its final position and tighten
the clamp screw (4). Be aware of the torque specified on the
1-arm socket (6) here too.
Thanks to the round rubber spacer (5), it is possible to move
the 1-arm socket (6) in all directions.
(12)
(5)
(7)
(4)
(6)
Bosch eBike Systems