Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL PANEL
3
2
1
1
2
Buttons
LED light indicators
1 - Timer
1 - Timer
2 - Swing
2 - Swing
3 - ON/OFF
3 - ON/OFF
4 - Cool
4 - Cool
5 - Speed
5 - Speed
6 -Numeric display
- Numeric LED display:
Shows setting time (from 1,2,3... until 24 h.)
Fault detection: If the sensor has problems, the digital panel displays E1.
REMOTE CONTROL
·
Remote controller control panel with the same function as the unit control panel
· Do not mix old and new batteries at the same time in remote controller.
· Take out the batteries when the remote is not in use for a long time.
CLEANING AND MAINTENANCE
· Unplug the appliance before cleaning.
· Empty water tank to avoid odor occurring when not in use.
· After few days operation, dust and dirt may reserve in water tank. It is recommended to change
water and clean water tank frequently.
· After long time operation, the filtration mesh becomes clogged with dust and dirt, which will
greatly affect the unit's performance. It is recommended to clean the filtration mesh frequently.
· Use a soft cloth to clean the appliance. Do not use solvents or harsh chemicals. Never use direct
water. Do not allow water to come in contact with the control panel.
· Do not clean with metal sourcing pads. It may scratch the surface or cause electrical shock.
6
4
5
5
4
3
EN
- ON/OFF: Press once this button to turn on the device.
It will start up with "MID" in 3 seconds and then revert to
work under the memorized status. If for first time use, it
will start up with "MID" in 3 seconds and then work with
"LOW". Press again this button to turn OFF.
- SPEED: Press SPEED button to select desired fan speed,
MID-HIGH-LOW, in circle turns. The corresponding air
flow speed indicator light will be displayed. Numeric
display shows 1.2.3.
- TIMER: It can be set between 1 to 24 hours, increase by
1 hour intervals.
- LEFT and RIGHT SWING: Press once this button to make
horizontal swing of vertical louvers, the SWING indicator
will be displayed. Press again to cancel this function.
Horizontal louvres can be adjusted manually.
- COOL: During operation, press this button to start
the evaporative cooling function, to humidify the air,
improve the air damp, avoid skin dry and spall. Before
press COOL button, make sure water in the tank is always
no less than min. level required. Press again this button
to cancel.
10
Publicidad
