Radio Reception
Tuning to radio stations
1
Select
TUNER
source.
TUMETR is displayed briefly.
2
Press
BAND
once or more to select your
waveband.
3
Press down on
TUNING
« or ►► and release
button,
-♦ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: 5CHRCH,
If a FM station is received in stereo,
stereo
is
shown.
4
Repeat step
3
if necessary until you find the
desired station.
• To tune to a weak station, press
TUNING
or ►► briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number From this preset number
upwards, former programmed radio stations will
be overridden.The system will only program
stations which are not in the memory already.
1
Press
PRESET
▼ or A (!◄ or ►! on the
'
it
remote control) to select the preset number
where programming should start.
*
Note:
—
If no preset number is selected, default is p^det
(1) and all your presets will be overridden.
2
Press
PROGRAM
for more than 2 seconds to
activate programming.
RLIFO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by AM. The last preset
automatically stored will then be played.
Manual programming
1
Tune to your desired station (seeTuning to radio
stations).
2
Press
PROGRAM
to activate programming,
-» PROGRAM flashes in the display.
*
3
Press
PRESET
▼ or A
or
W
on the remote
control) to allocate a number from 1 to 40 to
this station.
4
Press
PROGRAM
again to confirm the setting,
•+ PROGRAM
disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations,
• You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
•
Press
PRESET T
or
A
(on the remote control
14
orW ) until the desired preset station is
displayed.
16