Publicidad
Idiomas disponibles
Idiomas disponibles
General Information
This system complies with the FCC
rules.
Part
15 and with 21 CFR 1040.10.
Operation is subject to the following two
conditions:
- This device may not
cause
harmful
interference, and
-
This device must accept any interference
received, including interference that may
cause undesired operation.
Environmental Information
All unnecessary packaging has been omitted.We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet), .
Your system consists of materials which can be
recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment
Supplied accessories
- 2 speaker boxes
- remote control
- AM loop antenna
- FM wire antenna
Safety Information
•
Before operating the system, check that the
operating voltage indicated on the typeplate (or
the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not, please
consult your dealer
•
Place the system on a flat, hard and stable
surface.
•
Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 irfthes)
clearance from the rear and the top of Jhe unit
and 5 cm (2 inches) from each side.
•
Do not expose the system, batteries or discs to
excessive moisture, rain, sand or heat scJufces
caused by heating equipment or direct sunlight.
•
If the system is brought directly from a cold to a
warm location, or is placed in a very dalmp room,
moisture may condense on tllfe lens of the disc
unit inside the system, Should this occur the CD
player would not operate normally. Leave the
power on for about one hour with no disc in the
system until normal playback is possible,
•
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
0 When the system is switched to Standby
mode, it is still consuming some power.
To disconnect the system from the »
power supply completely, remove the AC
power plug from the wall socket.
Publicidad
