DeWalt D28730 Manual De Instrucciones página 24

ENglish
Fig. C
Block
Vise Operation (Fig. A)
The vise 6 has a quick-travel feature. To release the
vise when it is clamped tightly, turn the crank
counterclockwise one or two times to remove clamping
pressure. Lift vise lever 9 up. Pull crank assembly out as far
as desired. Vise may be pushed forward into work without
cranking. Lower vise lever
9
using crank 8 .
Fence Operation (Fig. A, D, E)

WARNING: Turn off and unplug the tool before
making any adjustments or removing or
installing attachments or accessories. Be sure the
trigger switch is in the OFF position.
The fence 5 can be adjusted two ways: to change desired
cutting angle and to change spacing between the fence
and vise.
To Change the Desired Cutting Angle
Use the hex key 7 provided to loosen (do not remove)
the two fence bolts 16 . Align the desired angle indicator
line with the slot line in the base
25
both fence bolts before use. For more accurate square
cuts, disconnect the power supply, loosen the two fence
bolts, push arm down until wheel extends into base. Place
a square against the wheel and adjust fence against the
square. Securely tighten both fence bolts before use. When
making a miter cut, the vise
depending on the thickness of the workpiece and the miter
angle. Other aids (such as spring, bar or C-clamps) will
be necessary to secure the work piece to the fence when
making these cuts.
Fig. D
16
5
22
Cut-off end
8
then tighten vise onwork by
6
. Securely tighten
4
may not clamp securely,
6
Fig. E
25
5
Removal and Installation of Wheels
(Fig. F, G)

WARNING: Turn off and unplug the tool before
making any adjustments or removing or
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. Do not make
any adjustment while the wheel is in motion. Do not
make any adjustment while chop saw is plugged into
power supply.
1. Push in spindle lock
until wheel lock lever engages slot in inside flange
to lock wheel. Loosen the bolt
the center of the abrasive wheel with the 5/16" (8 mm)
hex wrench 7 . Bolt has right-hand thread.
Fig. F
12
2. Remove the bolt
and old wheel 10
Fig. G
6
16
12 and rotate wheel 10 by hand
counterclockwise in
19
, washer , outside flange
19 20
.
18
10
21
18
21
20
19