KLS Martin group maXium smart Cart Instrucciones De Uso página 40

List to support the PE/POAG check:
Exterior
•
Corpus*, handle, basket, rear RGA plate*, bracket of the multiple socket*, isolating
transformer casing* (optional equipment), foot switch holder, standard rail* (optional
equipment), base frame, PA bolt (POAG)
Interior (metal parts accessible after opening the doors)
•
Cable duct* (optional equipment), electrical compartment plate, RGA storage shelf*, gas
cylinder retainer*, pivots
* is included into the testing upon commissioning via a bare contact point that has PE/PE
potential and is located at another position
4.3 Application
4.3.1 Basket
Use the basket (9, Fig. 4-2) to store accessories.
4.3.2 Storage Tray with Door
The storage tray (2, Fig. 4-1) can be used for storing the Instructions for Use or accessories.
Risk of injury from exceedance of the payload!
If the payload limit is exceeded, the tilting stability of the maXium
guaranteed any longer!
• Placing accessories on the cart must not result in tilting of the cart.
Observe the payload limit, see section 8 "Technical Data", page 47.
•
After every weight change, the tilting stability of the maXium
checked again.
— Place the loaded maXium
— Bring the castors into the most unfavorable position (rolls pointing inwards).
— Lock the brakes of the maXium
— Now the cart must not tip over in any position
If sufficient tilting stability is not ensured (e.g. maximum inclination of 5°), the cart must
•
be marked according to the labeling requirements.
40
All manuals and user guides at all-guides.com
®
smart Cart on a surface with an inclination of 10°.
®
smart Cart.
Gebrauchsanweisung
®
maXium smart Cart
®
smart Cart cannot be
®
smart Cart must be
Revision 1