stayer SC300W Manual De Instrucciones página 42

3.The machine does not have fuses although the
use of a dedicated magnetothermal switch
is recommended as a protection for the
machine.
4.The machine has class II electrical equipment so
that it does not make use of the grounding
of the electrical installation.
5 . I l l u s t r a t e d d e s c r i p t i o n o f
functions
1.Connecting/disconnecting switch
2.Locking button for continuous operation
3.Grip for the machine
4.Trigger for unlocking the upper position of
the head
5.Motor of the machine
6.Tiltable guard hood of the lower cutting table
7.Fastening of the adjusting system for fixed
cutting length / cutting extensor
8.Stopper guide
9.Adjusting system for fixed cutting length by
abutment / extension handle
10.Base of the machine
11.Hole for fastening the clamp
12.Rubber leg
13.Control for adjusting horizontal angle
14.Horizontal scale for lockable cutting angle
15.Lower cutting table
16.Cutting disk
17.Fastening flange for the cutting disk
18.Fastening screw for the cutting disk
19.Fastening washer for the cutting disk
20.Rear guard of the lower cutting table
21.Casing of the machine
22.Holes for fastening extension grip
23.Opening for fastening the adjusting system
for fixed cutting length
24.Transversal shaft
25.Particle outlet nozzle
26.Adjusting screw for maximum opening of
the head
27.Adjusting screw for maximum vertical inclination
of the head
28.Screw or control for fastening the head with
respect to the longitudinal axis
29.Longitudinal axis
30.Screw for adjusting the perpendicularity of the
head
ENGLISH
41
31.Screw for adjusting the resting position of
the head.
32.Knob for fastening the head in the horizontal
resting position.
33.Vertical angle indicator.
34.Unlocking device of the tiltable guard.
35.Scale of vertical angles.
36.Horizontal angle indicator.
37.Adjusting screws for the scale of vertical angles.
38.Upper cutting table.
39.Keel of the upper cutting table.
40.Wing nut of the shaft screw of the guard of the
upper table.
41.Locking screw of the guard of the upper table.
42.Movable guard of the upper table.
43.Frontal guide of the upper table.
44.Stopper for adjusting the cutting depth of the
guard of the upper table.
45.Lateral guide of the upper table.
46.Knob for adjusting the cutting height on the
upper table.
47.Adjusting screws for the position of the keel of
the upper table.
48.Fastening screws of the upper table.
49.Protective guard for cutting on the upper table.
50.Height reference scale for cutting on the upper
table.
51.Brush-holder lid.
52.Fastening screw for the brush-holder cover.
53.Brush-holder.
54.Brush-holder connecting screw.
55.Brush-pressing spring.
56.Brush.
57.Brackets for fixing the depth stop adjustment.
6.Limitations regarding
environmental conditions
The IP degree of this machine is 20. This machine is
protected against its dangerous parts being
accessed by a finger and against solid foreign
particles having diameters of 12'5 mm and more.
This machine does not have any kind of protection
against the entry of water so that its use in exterior
or interior environmental conditions with a risk of
precipitations is forbidden.
41