stayer SC300W Manual De Instrucciones página 49

Warning!
The height of the upper cutting table in respect of
the cutting disk must be such that the disk protrudes
from the workpiece only by a height equal to that of
the saw tooth. See image P.
1.If tightened, slightly loosen the screws 40 and 41
of the guard of table 38 such that the guard
ascends freely.
2.Loosen knob 46.
3.Adjust the height of the table 38 by smoothly
pulling or pushing it upwards. You may use
t h e s c a l e ( m e t r i c / i m p e r i a l ) 5 0 t h a t i s
i n t e g r a t e d w i t h i n t h e c a s i n g s o a s t o
reference constant heights
4.Firmly tighten knob 26.
Setting the cutting width on the upper table
by means of the guide
1.Release movement of the parallel guide 44 by
loosening the wing nut thereof.
2.Adjust the cutting width by moving the guide 44
with the graduated scale 43.
3.Fasten guide 44 by firmly tightening the wing nut
thereof.
Carrying out the working operation on the
upper cutting table
1.Carry out the starting operation with locking as
explained in chapter 12.
2.For longitudinal cuts use the parallel guide to
support the workpiece.
3.Approach the workpiece to the cutting disk
applying maximum caution keeping your
hands distanced from the cutting path.
4.Push the workpiece with an intensity that is
s u i t a b l e f o r t h e c h a r a c t e r i s t i c s o f t h e
material.
5.Carry out the stopping operation with locking as
explained in 12.
ENGLISH
48
Information!
Only for models SC300W, SC311W, SCE311W,
SC391W and SLL391W. Once it has been placed at
the left of the saw blade, parallel guide 44 allows
cutting small cuttings at 45º.
13.Precautions and protective
garment
This electrical tool may only be handled by adult
personnel who have received suitable training and
instructions, complying with laws as established to
this respect and what has been set forth as a matter
of prevention for the working place. In addition, the
operator must have understood and assimilated,
and fully comply with the present manual.
Questa macchina richiede l'utilizzo delle seguenti
attrezzature di protezione individuale:
1.Protective helmet
2.Integral face-protecting equipment (eyes and
face) against impacts
3.Ear protectors
4.Dust mask
5.Protective gloves against mechanical aggression
6.Boots with toe caps and insoles
7.Working garment
8.Tool bag
9.Safety belt (occasional)
48