RIDGID HD1600M0 Manual Del Usuario página 27

ASSEMBLY
Caster/Caster Foot Assembly
NOTE: Remove Powerhead Assembly
from Dust Drum prior to assembly of
Casters and Caster Feet.
1. Turn Dust Drum upside down on floor.
2. Place Caster Foot on floor. Insert the
stem of a Caster into socket of Caster
Foot.
3. Push on the Caster until the Caster ball
end snaps fully into the Socket and the
Caster swivel freely. Repeat for other
three Casters and Caster Feet.
4. Place Caster Foot with Caster over
post on bottom of Dust Drum and press
firmly in place, as shown.
5. Repeat for the other three Caster/
Caster Foot assemblies.
6. Four (4) Screws are available for
optional assembly of the caster feet
into the drum. If desired locate four (4)
#10 x 19 mm (3/4") Pan Head Screws in
loose parts bag. Insert a screw through
the hole in the Caster Foot and into the
Dust Drum. Tighten securely.
7. Turn the Dust Drum upright.
SP7053-2 HD1600M0 SE .indd 27
Caster
Caster Stem
Caster Ball
Optional
Hole for
Screw
Placement
Caster
Foot
Post
Dust
Drum
Wet/Dry Vac Assembly
Accessory Caddy Installation
1. Place the Two Tabs on the bottom
edge of the Accessory Caddy into the
Two Slots on the rear of the Dust Drum.
2. Pivot the top of the Accessory Caddy
upward until the Two Locking Tabs
engage the upper slots in the Dust
Drum. Press in on the top edge of the
Accessory Caddy until it snaps into
place. Check that the Locking Tabs
are securely locked by pulling outward
on the Accessory Caddy.
ASSEMBLED
Accessory
Caddy
27
Caster Foot
Caster Foot
Post Hole
Dust Drum
Locking
Tabs (2)
9/4/19 9:30 AM