Publicidad
Idiomas disponibles
Idiomas disponibles
2) Check and tighten any loose parts.
3) Have any damaged parts replaced or repaired in the Service Centre.
Stop the motor before cleaning or when clearing a blockage, or checking & carrying out maintenance
or working on the appliance; or adjusting the working position of the cutting device, or leaving the
appliance unattended.
Ensure that the appliance is correctly located in a designated working position before starting the
motor.
While operating, always ensure that the operating position is safe and secure.
Never use the appliance while standing on a ladder.
Do not use the appliance in the rain.
Do not operate the appliance with a damaged or excessively worn cutting device.
Always ensure that all handles and guards are fitted when using the appliance. Never attempt to use
an incomplete appliance or one fitted with an unauthorized modification.
Always use two hands to operate the appliance.
Always be aware of your surroundings and stay alert for possible hazards of which you might not be
aware due to the noise of the appliance.
When the hedge trimmer is stopped for servicing , inspection or storage, shut off the power source,
make sure all moving parts have come to a stop and disconnect the power plug. Allow the appliance to
cool before making any inspection, adjustments, etc.
Always allow the appliance to cool down before Storing.
When transport or storing, always fit the cutting device transport guard.
Have the appliance checked by qualified specialists. Use only the replacement parts recommended by
manufacturer.
SAFETY WARNINGS OF GRASS TRIMMER AND BRUSH CUTTER
a) Do not use the machine in bad weather conditions, especially when there is a risk of lightning. This
decreases the risk of being struck by lightning.
b) Thoroughly inspect the area for wildlife where the machine is to be used. Wildlife may be injured by
the machine during operation.
c) Thoroughly inspect the area where the machine is to be used and remove all stones, sticks, wires,
bones, and other foreign objects. Thrown objects can cause personal injury.
d) Before using the machine, always visually inspect to see that the cutter or blade and the cutter or
blade assembly are not damaged. Damaged parts increase the risk of injury.
e) Follow instructions for changing accessories. Improperly tightened blade securing nuts or bolts may
either damage the blade or result in it becoming detached.
f) The rated rotational speed of the blade must be at least equal to the maximum rotational speed
marked on the machine. Blades running faster than their rated rotational speed can break and fly
apart.
g) Wear eye, ear, head and hand protection. Adequate protective equipment will reduce personal injury
by flying debris or accidental contact with the cutting line or blade.
h) While operating the machine, always wear non-slip and protective footwear. Do not operate the
machine when barefoot or wearing open sandals. This reduces the chance of injury to the feet from
contact with the moving cutters or lines.
i)
While operating the machine, always wear safety footwear. Do not operate the machine when
barefoot or wearing open sandals. This reduces the chance of injury to the feet from contact with a
moving cutter, line or blade.
j)
While operating the machine, always wear long trousers. Exposed skin increases the likelihood of
injury from thrown objects.
k) Keep bystanders away while operating the machine. Thrown debris can result in serious personal
159
Publicidad
