Bosch GAS 18V-10 L Professional Manual Original página 18

18 | English
Battery Charge Indicator
When the rechargeable battery is inserted, you can see the
state of charge of the battery on the battery charge
indicator (4) on the dust extractor. When the rechargeable
battery is removed, you can see this on the battery itself.
Battery Charge Indicator on the Dust Extractor
After the dust extractor is switched on, the five green LEDs
of the battery charge indicator (4) will light up individually
one after another in ascending and descending order. Then
the LEDs will indicate the state of charge of the battery (20).
Battery Charge Indicator on the Rechargeable Battery
If the rechargeable battery is removed from dust extractor,
its state of charge may be indicated by the green LEDs of the
battery charge indicator on the battery.
Press the button for the battery charge indicator
show the state of charge.
If no LED lights up after pressing the button for the battery
charge indicator, then the battery is defective and must be
replaced.
Note: Not all battery types have a battery charge indicator.
Battery model GBA 18V...
LEDs
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Battery model ProCORE18V...
LEDs
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to
50 °C. Do not leave the battery in your car in the summer, for
example.
Occasionally clean the ventilation slots on the battery using a
soft brush that is clean and dry.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
1 609 92A 98S | (10.01.2024)
Follow the instructions on correct disposal.
Assembly
Remove the battery before cleaning or performing
u
maintenance on the dust extractor, making tool ad-
justments, changing accessories or placing the dust
extractor in storage. This safety measure prevents the
dust extractor from being started accidentally.
Fitting the Brackets for Extractor Accessories
(see figure B)
– Slide the bracket (25) for the suction tube and crevice
nozzle firmly into the adapter (10) provided for it from
above until it clicks into place.
– Slide the bracket (27) for the vacuum hose and floor
or to
nozzle firmly into the adapter (7) provided for it from
above and tighten the fixing bolts (26).
Fitting the vacuum hose (see figure C)
– Insert the vacuum hose (13) into the hose adapter (8) un-
til both snap fasteners (28) of the vacuum hose click into
place.
Note: The friction generated by the dust in the vacuum hose
and accessory during extraction causes an electrostatic
charge that the user may experience as static discharge (de-
Capacity
pending on environmental factors and their physiological
60−100 %
state).
30−60 %
Fitting the Vacuuming Accessories
5−30 %
The vacuum hose (13) is equipped with a clip system which
0−5 %
can be used to connect vacuuming accessories (dust extrac-
tion adapter (14), curved nozzle (15)).
Fitting the extraction adapter or curved nozzle
(see figure D)
Fit the extraction adapter (14) or the curved nozzle (15) to
the vacuum hose (13) until the two snap fasteners (28) on
Capacity
the vacuum hose audibly click into place.
80−100 %
To remove the adapter, press the snap fasteners (28) in-
60−80 %
wards and pull apart the components.
40−60 %
Fitting the Nozzles and Tubes
20−40 %
– If required, place the suction tubes (18) firmly inside one
5−20 %
another and then attach them firmly to the curved nozzle
(15).
0−5 %
– Attach the floor nozzle (17) or the crevice nozzle (16)
firmly to the suction tube (18) or the curved nozzle (15).
Attaching the Carrying Strap (Accessory)
(see figure E)
The carrying strap is only intended for carrying and at-
u
taching the dust extractor!
Click the snap hooks of the carrying strap (29) into the
fastening eyes (9) of the dust extractor.
Bosch Power Tools