Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL BY UNIVERSAL DMX CONTROLLER
DMX 512 Connection
DMX IN
DMX CONTROLLER
DMX INPUT
DMX INPUT
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. The last units DMX cable has to be terminated with a 120 ohm 1/4W resistor between
pin 2(DMX-) and pin 3(DMX+) of a 3-pin XLR-plug and plug it in the DMX-output of the last
unit.
3. Connect the chain link unit using an XLR connector from the output of the unit to the
input of the next unit. The cable cannot branch or split into a "Y" cable. DMX 512 is a very
high speed signal. Improper or damaged cables, soldered joints, or corroded connectors
can easily distort the signal and shut down the system.
4. The DMX output and input connectors are pass-through to maintain the DMX circuit,
when one of the units' power is disconnected.
5. Each fixture unit needs to have an address set to receive the data sent by the controller.
The address number is between 0-511 (usually 0 & 1 are equal to 1).
6. The end of the DMX 512 system should be terminated to reduce signal errors.
7. 3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+) 5 pin XLR: Pin 1:
GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin 4/Pin 5: Not used.
www.audibax.com
COMMON
DMX +
DMX -
COMMON
DMX +
DMX -
Not Used
Not Used
10
CHICAGO 475 ZOOM
DMX OUTPUT
DMX OUTPUT
PRO
DMX OUT
Publicidad
