Audibax CHICAGO 475 ZOOM Manual De Usuario página 6

CONTROL PANEL
1. Function Display:
Shows the various menus and the selected functions
2. LED:
POWER ON
DMX ON
3. Button:
MENU To select the programming functions
To go backward in the selected functions
DOWN
UP To go forward in the selected functions
ENTER To confirm the selected functions
4. DMX IN:
DMX512 connector, use 3/5-pin XLR cable to link the unit and the DMX controller
5. DMX OUT:
DMX512 connector, use 3/5-pin XLR cable to link the next unit and output DMX signal
6. MAINS IN:
PowerCon connection from main power supply
7. MAIS OUT:
PowerCon loop connection for main power supply to the next unit
8. Fuse (T 10A):
Protects the unit from over-voltage or short circuit
MAIN FUNCTION
To select any of the given functions, press the MENU button until the required function is
showing on the display. Select the function by pressing the ENTER button and the display
will blink. Use the DOWN/UP buttons to change the mode. Once the required mode has
been selected, press the ENTER button to setup, to go back to the functions without any
change press the MENU button again. Press and hold the MENU button for about one
second or wait for one minute to exit the menu mode.
The main functions are shown overleaf:
www.audibax.com
Power On
Activate DMX control
4
CHICAGO 475 ZOOM
PRO