Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY AND OPERATION
ACTION
Charging The Battery Pack
Installing/ Removing The Battery
Pack
Tool-Less Blade Fitting
On/Off Operation
NOTE: LED light will illuminate the
working zone automatically when
the product is switched on.
NOTE: Your saw is equipped with a
lock-off button. Press the lock-off
button to lock the trigger switch.
Always lock the trigger switch when
carrying or storing the machine.
Variable Speed Control
Hand Grip Area
Footplate Adjustment
NOTE: Adjust the position of
footplate according to the blade
length and workpiece thickness;
always ensure that the blade
extends beyond the workpiece
throughout the stroke.
Pendulum Selector Knob
Adjust the pendulum speed
according to the workpiece material
and thickness.
OFF position: Fine cuts in thin
workpieces; cutting surface quality
is more preferred than speed;
cutting metal.
ON position: Fast cuts in soft
materials (e.g. softwood); cutting in
the direction of the wood grain.
Flush Cutting
Wood Cutting
Metal Cutting
Plastic / Aluminum Cutting
Pocket Cutting (Soft Materials Only)
WORKING HINTS FOR YOUR
CORDLESS RECIPROCATING
SAW
If your power tool becomes too hot, set the speed to
maximum and run a no load for 2-3 minutes to cool the
motor.
Cordless Reciprocating Saw
Always ensure the work-piece is firmly held or clamped to
prevent movement.
The blade guard must be held firmly against the material
being cut to reduce saw vibration, blade jumping and blade
FIGURE
breakage.
See Fig. A1
MAINTENANCE
See Fig.A2
Remove the battery pack from the tool before
See Fig. B
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
See Fig. C1
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
See Fig. C2
For Battery tools
See Fig. D
The ambient temperature range for the use and storage of
tool and battery is 0
The recommended ambient temperature range for the
charging system during charging is 0
See Fig. E1,
E2, E3
ENVIRONMENTAL
PROTECTION
recycling advice.
See Fig. F
See Fig. G, H
See Fig. I
See Fig. J
See Fig. K
See Fig. L
C-45
C.
o
o
Waste electrical products must not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authorities or retailer for
C-40
C).
o
o
EN
11
Publicidad
